by machinist:-) (Posted Mon, 27 Jun 2016 20:33:44 GMT)
mightbe the 1/2 in endmill just barely fit into tight areas..
and smaller endmill makes a longer path versus the 1/2 endmill just plunging into..
but... without picture its only guessing..
and we don't want to looking dummy after comes up not this the error..
as it happened before many times.. some ask abpout an issue we try our best and comes up the question was wrong initially...
not too long time before one asked why the motors are stalling, we tried to say might need a stronger motor..
eventually the original poster came up with a set acceleration, a race car would fall apart on that acceleration..
so please post first picture.. or all help will be just useless..
Read Main Topic
mightbe the 1/2 in endmill just barely fit into tight areas..
and smaller endmill makes a longer path versus the 1/2 endmill just plunging into..
but... without picture its only guessing..
and we don't want to looking dummy after comes up not this the error..
as it happened before many times.. some ask abpout an issue we try our best and comes up the question was wrong initially...
not too long time before one asked why the motors are stalling, we tried to say might need a stronger motor..
eventually the original poster came up with a set acceleration, a race car would fall apart on that acceleration..
so please post first picture.. or all help will be just useless..
Read Main Topic