by rtech (Posted Wed, 22 Jun 2016 00:53:49 GMT)
I have an issue running models that I create using Artcam Express 2015 I am using my machine is using Mach3. When I save my gcode (.tap) I get lines in my code G1Z-0.0250F4.0 that causes the tool to plunge into the material. Can someone help me determine what is going on? This is happening with every model I attempt to run from ArtCam. I have attempted vcarve and machine relief and get the same results.
Read Main Topic
I have an issue running models that I create using Artcam Express 2015 I am using my machine is using Mach3. When I save my gcode (.tap) I get lines in my code G1Z-0.0250F4.0 that causes the tool to plunge into the material. Can someone help me determine what is going on? This is happening with every model I attempt to run from ArtCam. I have attempted vcarve and machine relief and get the same results.
Read Main Topic