by Rusty2 (Posted Tue, 26 Apr 2016 06:33:43 GMT)
I do a lot of aluminum, 5052 is good single flute I run at 2000 rpm and no deeper than 1.3 mm step down . great chip load supper clean cut I use a mister with olive oil and 10% solvent ( hey works for me) just did a run O problems . hope this helps
Read Main Topic
I do a lot of aluminum, 5052 is good single flute I run at 2000 rpm and no deeper than 1.3 mm step down . great chip load supper clean cut I use a mister with olive oil and 10% solvent ( hey works for me) just did a run O problems . hope this helps
Read Main Topic